Isilon OneFS must be 7.1 or higher
(Source) isi sync policies list
--> Displays a list of Policies on the isilon. Find the Policy in Ref to your share.
i.e.
isilon1-1# isi sync policies list
Name Path Action Enabled Target
------------------------------------------------------------------------------------------------------------------------------------
ChrisTest /ifs/data/Isilon_Support/DRtest sync Yes isilon02.isilon.local
------------------------------------------------------------------------------------------------------------------------------------
Total: 1
(Source) isi sync policies disable --policy=<policy>
i.e. isi sync policies disable --policy=ChrisTest
(Source) isi sync policies list
--> look for a "No" in the Enabled column
(DR) isi sync target list
i.e.
isilon1-1# isi sync target list
Name Source Target Path Last Job State FOFB State
----------------------------------------------------------------------------------------------------------------------------------
ChrisTest isilon02 /ifs/data/Isilon_Support/DRtest finished writes_disabled
---------------------------------------------------------------------------------------------------------------------------------
Total: 1
Find the Target Name, which is the policy name to use below in the next command.
(DR) isi sync recovery allow-write --policy-name=<policy>
i.e. isi sync recovery allow-write --policy-name=ChrisTest
(DR) isi sync target list
Verify that writes_enabled in FOFB State
i.e.
isilon1-1# isi sync target list
Name Source Target Path Last Job State FOFB State
----------------------------------------------------------------------------------------------------------------------------------
ChrisTest isilon02 /ifs/data/Isilon_Support/DRtest finished writes_enabled
---------------------------------------------------------------------------------------------------------------------------------
Total: 1
#after DR Exercise is done and they dont want the changes to go back to Prod, issue the revert command.
(DR) isi sync recovery allow-write --policy-name=<policy> --revert
(Source) isi sync policies enable --policy=<policy>
i.e. i.e. isi sync policies enable --policy=ChrisTest
(Source) isi sync policies list
--> List the policy settings action should be "sync" and enabled should be "yes"
#below command is issued only if needed, which is typically needed if the policy wasn't disabled at the start of the exercise.
(Source) isi sync policies resolve --policy=<policy> --force